Light Aviation
Flowmeter (with the dispenser) is designed for installation in vehicles sprayed fields chemicals, ultra low volumes (ULV). In particular, can be installed on machines having a board voltage from 9 to 16 volts, ie, automotive power. In our time, a widespread technique which make ulv (ultra low volumes) is the als (Ultra Light Aviation), ultralights, aircraft and land vehicles (any kind of lunar rover):) Name device already speaks for itself and serves to calculate the actual instantaneous flow rate in liters per hectare as well as sumarnogo fluid flow. Credit: actress-2011. It’s all about flow! And finally the main function of the device – this dosage liquid, or chemical solutions per hectare for a given preset. As you work all the presets can be easily modified. In the presets you can set the speed at which it only needs leash for the shedding of chemical solutions while standing on one place when driving speed is taken from the testimony of a gps module built-in dispenser. Just not a few important parameter is preset width.
Dosage happening in two ways 1-d) The main method of control duty-cycle voltage applied to the himpompu (shown in a very good side), 2 nd) Managing electro-cock The panel has 5 buttons (design of the case and buttons may vary) 1 button – bust paging modes (for each button goes to the next mode) 2 button – up or (+); button 3 – or down (-), 4 button – to save the settings or simply (s), 5 button – reset (reset) . The flowmeter has 7 modes: one mode – this is main mode display instantaneous flow rate and total amount of liquid spills. 2 mode – this map is the engine speed and voltage on-board network. When you click ok, return to the main mode. 3 mode speeds.
Here exhibited the speed at which you process. In the future when connecting gps speed will be displayed automatically, or rather with the navigator. The ok button saves and then goes into basic mode. A reset button puts default speed of 90 km / h. 4 Select mode of capture. Everything is configured the same speed. 5 ecm flow. Suppose you have a dimensional capacity of 100 liters, having spent the 100 liters if flowmeter showed 95 then you can easily buttons to adjust up or down to the desired value in our case from 95 to 100. Accordingly, uc keeps resetting expose defaults. 6 modes of selection of liquid flow per hectare. In the regime of hoppers passes from the main mode simply pressing the up or down. It is convenient to change the flow on the fly. ok saves and returns to the core. 7 mode puts the power start the pump. And displays the percentage of pump power at the cost. When you press ok button saves the percentage to start the pump.